Cruise Control System Tc And Cg Terminal Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK WIRE HARNESS (TC OF DLC3 - ECM)
CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)
CHECK WIRE HARNESS (TC OF DLC3 - BODY GROUND)
CRUISE CONTROL SYSTEM - TC and CG Terminal Circuit |
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.- HINT:
- When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK WIRE HARNESS (TC OF DLC3 - ECM) |
Disconnect the A7 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
A7-3 (TC) - L16-13 (TC)
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR (DLC3 - ECM) |
|
|
| 2.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND) |
Measure the resistance of the connector.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
L16-4 (CG) - Body ground
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
|
|
| 3.CHECK WIRE HARNESS (TC OF DLC3 - BODY GROUND) |
Measure the resistance of the connector.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
L16-13 (TC) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE WIRE HARNESS AND EACH ECU |
|
|
