Dtc C15C6/77 Ig Power Supply Voltage Malfunction
Steering. Lexus Gs430, Gs300. Uzs190 Grs190
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK STEERING CONTROL ECU
CHECK DTC
DTC C15C6/77 IG Power Supply Voltage Malfunction |
DESCRIPTION
The steering control ECU monitors IG power supply voltage.If the steering control ECU detects a malfunction, it will turn on the master warning light, store DTC C15C6/77, and stop VGRS operation.DTC No.
| DTC Detecting Condition
| Trouble Area
|
C15C6/77
| The steering control ECU detects that the battery voltage is normal and the IG terminal voltage is less than 4 V for 6 seconds.
| - ECU-IG LH fuse
- IG circuit
- Charging system
- Steering control ECU
|
WIRING DIAGRAM
INSPECTION PROCEDURE
- CAUTION:
- The fault may be intermittent. Check harnesses and connectors thoroughly and retest.
| 1.CHECK STEERING CONTROL ECU |
Record and clear the DTCs (Click here).
Start the engine.
Measure the voltage according to the value(s) in the table below.
- Voltage:
Tester connection
| Specified condition
| Proceed to
|
A42-3 (IG) -
A42-7 (PGND)
| 9 to 16 V
| A
|
A42-3 (IG) -
A42-7 (PGND)
| Below 9 V
| B
|
A42-3 (IG) -
A42-7 (PGND)
| Above 16 V
| C
|
| | CHECK OR REPAIR HARNESS AND FUSE |
|
|
| | CHECK AND REPAIR CHARGING SYSTEM |
|
|
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Check for DTCs (Click here).
- OK:
- DTC C15C6/77 is not output.
| | REPLACE STEERING CONTROL ECU |
|
|
