Rear Propeller Shaft Assembly (For 3Uz-Fe) Reassembly

Using SST and a press, install a new dust deflector No.1.

SST

09506-35010
09316-60011(09316-00011)

NOTICE:

Be careful not to damage the dust deflector.

Using SST and a press, install the center support bearing assembly No.1.

SST

09330-50010

NOTICE:

Be sure to install the bearing in the correct direction.

Using SST and a press, insert a new dust deflector until it almost touches the rubber of the center support bearing assembly No.1.

SST

09608-00071
09608-06041

NOTICE:

Be careful not to damage the dust deflector No.2.

Using SST and a press, install a new dust deflector No.2.

SST

09330-50010

Using a snap ring expander, install a new snap ring.

Install the dust boot.

NOTICE:

Assemble propeller intermediate shaft assembly after wrapping vinyl tape around the spline so that it will not damage the boot.

Apply grease to the spline.

Grease:

Molybdenum disulphide lithium base, NLGI No.2

Align the matchmarks and assemble the intermediate shaft and propeller shaft.

Cover the adjusting nut with the dust boot.

NOTICE:

The directions of the intermediate shaft companion flange and the propeller shaft companion flange should differ by 180°.

Fully tighten the adjusting nut by hand.