Park / Neutral Position Switch Installation

Install the park/neutral position switch to the manual valve shaft.

Temporarily install the bolt.

Install a new lock washer with the nut.

Torque:

6.9 N*m{70 kgf*cm, 61 in.*lbf}

Temporarily install the control shaft lever.

Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

Remove the transmission control shaft lever.

Align the neutral basic line with the switch groove, and tighten the adjusting bolt.

Torque:

13 N*m{133 kgf*cm, 9 ft.*lbf}

Using a screwdriver, bend the tabs of the lock washer.

Install the transmission control shaft lever RH with the nut.

Torque:

16 N*m{163 kgf*cm, 12 ft.*lbf}

Connect the park/neutral position switch connector.

Install the engine rear mounting member to the automatic transmission assembly with the 4 nuts.

Torque:

13 N*m{133 kgf*cm, 10 ft.*lbf}

Install the engine rear mounting member to the body with the 4 bolts.

Torque:

26 N*m{260 kgf*cm, 19 ft.*lbf}

Install the floor shift gear shifting rod sub-assembly with the nut.

Torque:

13 N*m{130 kgf*cm, 9 ft.*lbf}

Remove the nut and disconnect the shifting rod.

Turn the control shaft lever of the neutral start switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.

NOTICE:

Do not push the shift lever too hard.

After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.

When shifting from the P to the R position with the engine switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

Measure resistance according to the value(s) in the table below when the shift lever is moved to each position.

Standard resistance:

Shift Position	Tester Connection	Specified Condition
P	2 - 6 and 4 - 5	Below 1 Ω
Except P	↑	10 kΩ higher
R	1 - 2	Below 1 Ω
Except R	↑	10 kΩ higher
N	2 - 9 and 4 - 5	Below 1 Ω
Except N	↑	10 kΩ higher
D, S, "+" and "-"	2 - 7	Below 1 Ω
Except D, S, "+" and "-"	↑	10 kΩ higher

Install the engine under cover air guide bracket with the 2 bolts.

Torque:

26 N*m{260 kgf*cm, 19 ft.*lbf}

Install the under cover with the 4 screws, 2 grommets and 2 spacers.