Fuel Pressure Pulsation Damper Removal

Engine. Lexus Gs430, Gs300. Uzs190 Grs190
3Uz-Fe Fuel. Lexus Gs430, Gs300. Uzs190 Grs190

  1. DISCHARGE FUEL SYSTEM PRESSURE

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE V-BANK COVER

  4. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

Fuel Pressure Pulsation Damper -- Removal



1. DISCHARGE FUEL SYSTEM PRESSURE
NOTICE:
  1. Perform the following procedures to prevent fuel from spilling out before removing any fuel system parts.
  1. Pressure will still remain in the fuel line even after performing the following procedures. When disconnecting the fuel line, cover it with a shop rag or a piece of cloth to prevent fuel from spraying.

  1. Remove the F/PMP fuse.

    1. Remove the engine room No. 2 relay block cover upper.

    2. Remove the F/PMP fuse.

    3. Start the engine.

    4. After the engine has stopped, turn the engine switch off.

      HINT:
      DTC P0171/25 (fuel problem) and/or P0191/49 (fuel pressure sensor signal error) may be detected.

    5. Crank the engine again. Check that the engine does not start.

    6. Remove the fuel tank cap to discharge pressure from the fuel tank.

    7. Reinstall the F/PMP fuse.

  1. Disconnect the fuel pump connector.

    1. Remove the rear seat cushion.

    2. Remove the rear floor service hole cover.

    3. Disconnect the fuel pump connector.

    4. Start the engine.

    5. After the engine has stopped, turn the engine switch off.

      HINT:
      DTC P0171/25 (fuel problem) and/or P0191/49 (fuel pressure sensor signal error) may be detected.

    6. Crank the engine again. Check that the engine does not start.

    7. Remove the fuel tank cap to discharge pressure from the fuel tank.

    8. Reconnect the fuel pump connector.

    9. Install the rear floor service hole cover.

    10. Install the rear seat.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. REMOVE V-BANK COVER

  1. Remove the 2 nuts and cover.



4. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


Lexus Gs430, Gs300. Uzs190 Grs190

  1. Remove the fuel pulsation damper and 2 gaskets, and disconnect the fuel main tube from the fuel pump.