Stop Light Switch On-Vehicle Inspection

Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Lighting (Ext). Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. INSPECT STOP LIGHT SWITCH

Stop Light Switch -- On-Vehicle Inspection



1. INSPECT STOP LIGHT SWITCH

  1. Disconnect the stop light switch connector.



    Land Cruiser. Urj200, 202 Grj200 Vdj200.Lighting (Ext).Lighting System.Stop Light Switch On-Vehicle Inspection

  1. Measure the resistance and voltage on the wire harness side connector according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    A73-3 (GND) - Body ground
    		Always
    		Below 1 Ω
    Standard Voltage:
    Tester Connection
    		Condition
    		Specified Condition
    A73-1 (B) - A73-3 (GND)
    		Always
    		11 to 14 V
    A73-5 (B) - A73-3 (GND)
    		Engine switch on (IG)
    If the result is not as specified, repair or replace the wire harness or connector.
    Text in Illustration
    *a
    		Front view of wire harness connector
    (to Stop Light Switch Assembly)

  1. Reconnect the stop light switch connector.



    Land Cruiser. Urj200, 202 Grj200 Vdj200.Lighting (Ext).Lighting System.Stop Light Switch On-Vehicle Inspection

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Condition
    A73-2 (L) - A73-3 (GND)
    		Brake pedal not depressed
    		0 to 1.5 V
    Brake pedal depressed
    		7.5 to 14 V
    A73-4 (L) - A73-3 (GND)
    		Ignition switch on (IG)
    Brake pedal not depressed
    		7.5 to 14 V
    Ignition switch on (IG)
    Brake pedal depressed
    		0 to 1.5 V
    If the result is not as specified, replace the stop light switch assembly.
    Text in Illustration
    *a
    		Component with harness connected
    (Stop Light Switch Assembly)