Rear Combination Light Assembly (For Double Swing Out Type) -- Removal |
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH |
Put protective tape around the rear combination light assembly LH.
Text in Illustration *1 Protective tape
 |
Remove the 2 bolts.
Detach the 3 clips, 2 guides and 2 claws.
- NOTICE:
- Detach the bolt installation bracket from inside the body while being careful not to bend it.
Disconnect the connector to remove the rear combination light assembly.
| 2. REMOVE REAR TURN SIGNAL LIGHT BULB |
Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.
 |
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly LH.
| 3. REMOVE TAIL AND STOP LIGHT BULB |
Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.
 |
Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly LH.
| 4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH |
Using a screwdriver, detach the claw.
 |
Detach the 2 guide and remove the rear combination light socket and wire sub-assembly LH.