Relay (W/ Headlight Cleaner System) Installation

Install the headlight cleaner control relay in the direction shown in the illustration.

Connect the connector.

Temporarily install the windshield washer jar with the 4 bolts.

Tighten the 4 bolts in the order shown in the illustration to install the windshield washer jar.

Torque:

8.0 N*m{82 kgf*cm, 71 in.*lbf}

Connect the headlight cleaner hose to the windshield washer jar and pump.

Connect the 2 connectors.

Attach the clamp.

Install the washer inlet with the clip.

Connect the washer hose to the windshield washer motor and pump, and fill the washer jar with washer fluid.

Install the fender liner with the 12 clips and 2 new grommets.

Using a T30 "TORX" socket, install the 2 screws.

Install the 2 screws.

Clean the vehicle body surface.

1. Using a heat light, heat the vehicle body surface.
   

2. Remove the double-sided tape from the vehicle body.
   

3. Wipe off any tape adhesive residue with cleaner.
   

If reusing the rocker panel moulding:
Clean the rocker panel moulding.

1. Using a heat light, heat the rocker panel moulding.
   

2. Remove the double-sided tape from the rocker panel moulding.
   

3. Wipe off any tape adhesive residue with cleaner.
   





4. Apply new double-sided tape to the rocker panel moulding, as shown in the illustration.
   
   

   
   
   
   

Install the rocker panel moulding.

1. Using a heat light, heat the vehicle body and rocker panel moulding.
   

2. Remove the peeling paper from the face of the rocker panel moulding.
   

   HINT:

   After removing the peeling paper, keep the exposed adhesive free from foreign matter.

3. Attach the 10 clips to install the rocker panel moulding.
   





4. Install the 8 side mudguard retainers and screw.
   
   

   
   
   
   

Install the side step with the 6 bolts.

Torque:

30 N*m{306 kgf*cm, 22 ft.*lbf}

Install the mudguard with the clip.

Using a T30 "TORX" socket, install the 4 screws.