Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Wiper Washer. Land Cruiser. Urj200, 202 Grj200 Vdj200
Washer Nozzle (For Front Side) -- Removal |
- HINT:
- Use the same procedure for the LH and RH sides.
- The procedure listed below is for the LH side.
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3. REMOVE UPPER RADIATOR SUPPORT SEAL |
Remove the 7 clips and radiator support seal.
| 4. REMOVE FRONT FENDER MAIN SEAL LH |
Using a clip remover, detach the 3 clips and remove the fender main seal.
 |
| 5. REMOVE FRONT FENDER MAIN SEAL RH |
- HINT:
- Use the same procedure described for the LH side.
| 6. REMOVE FRONT WIPER ARM LH |
Remove the nut, wiper arm and blade.
| 7. REMOVE FRONT WIPER ARM RH |
Remove the nut, wiper arm and blade.
| 8. REMOVE HOOD TO COWL TOP SEAL |
Using a clip remover, detach the 12 clips, 4 clamps and remove the hood to cowl top seal.
 |
| 9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
Remove the washer hose.
 |
Remove the 2 clips.
 |
Detach the 17 claws and remove the cowl top ventilator louver sub-assembly.
| 10. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o PTC Heater) |
Detach the 3 claws and remove the washer nozzle.
 |
Disconnect the hose.
| 11. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ PTC Heater) |
Detach the connector clamp and disconnect the connector.
 |
Disconnect the hose.
Detach the 4 claws and remove the washer nozzle.
 |