Power Window Control System (For Models With Jam Protection Function On Driver Door Window Only) Operation Check

Check that the front passenger side power window and the rear power windows cannot be operated when the window lock switch of the multiplex network master switch is pressed.

OK:

Operation of front passenger side power window and rear power windows are disabled.

Check that the front passenger side power window and the rear power windows can be operated when the window lock switch is pressed again.

OK:

Front passenger side power window and rear power windows can be operated.

Check that the driver side power window operates as follows:

Check that the front passenger side and rear power windows operate as follows:

Check that the driver side power window operates as follows:

Check that the front passenger side and rear power windows operate as follows:

Check that all the power windows can be operated with the multiplex network master switch after the ignition switch is turned off.

Check that the key-off operation function does not operate after a front side door is opened.

Check that all the power windows cannot be operated after more than approximately 45 seconds have elapsed since the ignition switch was turned off.

Check the basic function.

CAUTION:

1. The jam protection function is operative during both the auto up and manual up operation.
   
2. Do not put your fingers between the door frame and door glass to check functions. Also, prevent any part of your body from being caught during inspection.
   

HINT:

The jam protection function is operative during both the auto up and manual up operation while the engine is running or the ignition switch is ON, and also 45 seconds after the ignition switch is off.

1. Fully open the window.
   





2. Hold a thick book wrapped with cloth in the position shown in the illustration.
   

3. Operate the auto up or manual up function to check that the power window goes down when the window contacts the book, and stops when the opening reaches approximately 200 mm (7.87 in.).
   

   HINT:

   The power window moves down approximately 125 mm (4.93 in.). However, when the opening does not reach 200 mm (7.87 in.), the power window continues to go down until the opening reaches 200 mm (7.87 in.) or until approximately 5 seconds. have elapsed.

4. While the power window is moving down, check that the door glass cannot be moved up even when the power window regulator switch is used.
   

Check the basic operation.

HINT:

The catch protection function operates when the engine switch is on (IG), and when auto down and manual down are operated after the engine switch is turned off.

1. Fully close all door windows.
   

2. While using auto down or manual down to open the window, grasp the upper edge of the door glass with one or two hands and check that the door glass operation stops.
   

   HINT:

   After the catch protection function operates when an auto down or manual down operation is performed, the catch protection function will not operate when the manual down operation is performed again within approximately 4 seconds.

Check the LED illumination.

1. Check that the LED located on the power window regulator switch illuminates when the ignition switch is ON and the window lock switch is off.
   

Disconnect the power window regulator motor.

Connect the ammeter's positive (+) lead to terminal 2 of the wire harness side connector and the negative (-) lead to battery's negative terminal.

Connect the battery's positive (+) lead to terminal 1 of the wire harness side connector, and raise that window to the fully closed position.

Continue to apply voltage, and check that the current changes to less than 1A within 4 to 90 seconds.

Disconnect the leads from the terminals.

Approximately 60 seconds later, connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, and check that the window begins to lower.

NOTICE:

If the result is not as specified, replace the power window regulator motor.