Wireless Charging System Wireless Charger Illumination Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
WIRELESS CHARGING SYSTEM - Wireless Charger Illumination Circuit |
DESCRIPTION
When the light control switch is turned to the TAIL or HEAD position, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- Troubleshoot the wireless charging system after confirming that the lighting system is functioning properly. (Click here)
| 1.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL) |
Disconnect the mobile wireless charger cradle assembly connector.
Text in Illustration*a
| Front view of wire harness connector (to Mobile Wireless Charger Cradle Assembly)
|
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
E150-7 (TAIL) - Body ground
| Headlight dimmer switch assembly set to TAIL or HEAD
| 11 to 14 V
|
Headlight dimmer switch assembly off
| Below 1 V
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| OK |
|
|
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here) |
|
