Heating Air Conditioning. Air Conditioning Pressure Sensor Installation

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200

Heating Air Conditioning. Land Cruiser. Urj200, 202 Grj200 Vdj200

Air Conditioning Pressure Sensor -- Installation

1. INSTALL AIR CONDITIONER PRESSURE SENSOR

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent

2. CHARGE REFRIGERANT

SST: 09985-20010(09985-02130,09985-02150,09985-02090,09985-02110,09985-02010,09985-02050,09985-02060,09985-02070)

Charge refrigerant HFC-134a (R134a).

Standard:
Condenser Core Thickness	Air Conditioning Type	Cool Box	Refrigerant Charging Amount
22 mm (0.866 in.)	w/o Rear Cooler	w/ Cool Box	870 +/-50 g (30.7 +/-1.76 oz.)
	w/o Rear Cooler	w/o Cool Box	870 +/-50 g (30.7 +/-1.76 oz.)
	w/ Rear Cooler	w/ Cool Box	1010 +/-50 g (35.6 +/-1.76 oz.)
	w/ Rear Cooler	w/o Cool Box	970 +/-50 g (34.2 +/-1.76 oz.)
16 mm (0.630 in.)	w/o Rear Cooler	w/ Cool Box	770 +/-50 g (27.2 +/-1.76 oz.)
	w/o Rear Cooler	w/o Cool Box	770 +/-50 g (27.2 +/-1.76 oz.)
	w/ Rear Cooler	w/ Cool Box	970 +/-50 g (34.2 +/-1.76 oz.)
	w/ Rear Cooler	w/o Cool Box	920 +/-50 g (32.5 +/-1.76 oz.)

Do not operate the cooler compressor before charging refrigerant as the cooler compressor will not work properly without any refrigerant, and will overheat.
Approximately 100g (3.53 oz.) of refrigerant may need to be charged after bubbles disappear. The refrigerant amount should be checked by measuring its quantity, and not with the sight glass.

3. WARM UP ENGINE

Warm up the engine at less than 1850 rpm for 2 minutes or more after charging the refrigerant.
NOTICE:
Be sure to warm up the compressor when turning the A/C switch is on after removing and installing the cooler refrigerant lines (including the compressor), to prevent damage to the compressor.

4. CHECK REFRIGERANT GAS LEAK

After recharging the refrigerant gas, check for refrigerant gas leakage using a halogen leak detector.

Perform the operation under these conditions:
1. Stop the engine.
2. Secure good ventilation (the halogen leak detector may react to volatile gases other than refrigerant, such as evaporated gasoline or exhaust gas).
3. Repeat the test 2 or 3 times.
4. Make sure that some refrigerant remains in the refrigeration system. When compressor is off: approximately 392 to 588 kPa (4.0 to 6.0 kgf/cm², 57 to 85 psi).

If a gas leak is not detected on the drain hose, remove the blower motor control (blower resistor) from the cooling unit. Insert the halogen leak detector sensor into the unit and perform the test.

Disconnect the connector and wait for approximately 20 minutes. Bring the halogen leak detector close to the pressure switch and perform the test.

5. INSTALL FRONT BUMPER COVER