INSTALL REAR CRANKSHAFT OIL SEAL

INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Apply MP grease to the lip of a new oil seal.

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

• SST
• 09223-56010

• NOTICE:

Using SST, hold the crankshaft.

• SST
• 09213-70011
  09330-00021

Install the crankshaft angle sensor rotor.

Text in Illustration

Engine Side

• HINT:

Install the drive plate and rear drive plate spacer onto the crankshaft.

Text in Illustration

*1	Drive Plate
*2	Rear Drive Plate Spacer
	Automatic Transmission Side

• HINT:

• As the rear drive plate spacer and the drive plate are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

Install the drive plate and ring gear and bolts.

• HINT:

• The bolts are tightened in 2 progressive steps.

Clean the bolts and bolt holes.

Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.

• Adhesive:
• Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Text in Illustration

*1

Adhesive

Step 1:

Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.

• Torque:
• 30 N*m{ 301 kgf*cm, 22 ft.*lbf}

• NOTICE:

Do not reuse the drive plate installation bolts.

Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

Mark the upside of each drive plate installation bolt with paint.

Step 2:

Tighten the cylinder head bolts another 90°.

Check that the painted marks are now at a 90° angle to the upside.

• NOTICE:

• Do not start the engine for at least an hour after installing the drive plate.