Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1GR-FE ENGINE MECHANICAL
REAR CRANKSHAFT OIL SEAL - REMOVAL
| 1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission) |
()
| 2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission) |
()
| 3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission) |
Using SST, hold the crankshaft.
- SST
- 09213-54015(91651-60855)
09330-00021
Remove the 8 bolts, rear spacer, drive plate and front spacer.
- NOTICE:
- Do not reuse the bolts.
| 4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission) |
Put matchmarks on the clutch cover and flywheel.
Loosen each set bolt one turn at a time until spring tension is released.
Remove the 6 set bolts, and pull off the clutch cover.
- NOTICE:
- Do not drop the clutch disc.
| 5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission) |
- NOTICE:
- Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.
| 6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) |
Using SST, hold the crankshaft.
- SST
- 09213-54015(91651-60855)
09330-00021
Remove the 8 bolts and flywheel.
- NOTICE:
- Do not reuse the bolts.
| 7. REMOVE REAR CRANKSHAFT OIL SEAL |
Using a knife, cut off the lip of the oil seal.
| *1 | Cut Position |
Using a screwdriver, pry out the oil seal.
- NOTICE:
- Do not damage the surface of the oil seal press fit hole or crankshaft.
- HINT:
- Tape the screwdriver tip before use.