Meter / Gauge System Voltage Meter Malfunction

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200

Meter Gauge Display. Land Cruiser. Urj200, 202 Grj200 Vdj200

INSPECTION PROCEDURE

INSPECT FUSE (METER)

PERFORM ACTIVE TEST USING GTS (VOLTMETER)

CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

METER / GAUGE SYSTEM - Voltage Meter Malfunction

DESCRIPTION

The voltmeter indicates the voltage applied to the IG+ terminal of the combination meter.

WIRING DIAGRAM

Land Cruiser. Urj200, 202 Grj200 Vdj200.Meter Gauge Display.Meter / Gauge System.Meter / Gauge System Voltage Meter Malfunction

INSPECTION PROCEDURE

1.INSPECT FUSE (METER)

Remove the METER fuse from the engine room relay block.

Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
METER fuse
Always
Below 1 Ω

NG

REPLACE FUSE

OK

2.PERFORM ACTIVE TEST USING GTS (VOLTMETER)

Operate the GTS according to the display and select Active Test (Click here).

Combination Meter
Tester Display
Test Part
Control Range
Diagnostic Note
Volt meter Operation
Voltmeter
0, 3, 6, 9, 12, 15, or 18
Perform the test with the vehicle stopped and engine idling.
OK:
Needle indication is normal.

NG

REPLACE COMBINATION METER ASSEMBLY (Click here)

OK

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

Disconnect the E119meter connector.

Measure the resistance and voltage according to the value(s) in the tables below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
E119-20 (ET) - Body ground
Always
Below 1 Ω
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E119-22 (IG+)
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

REPLACE COMBINATION METER ASSEMBLY (Click here)