Dtc C1611 Ecu Malfunction

DESCRIPTION

INSPECTION PROCEDURE

READ VALUE USING GTS

SETTINGS (PARKING ASSIST ECU INITIALIZATION)

CHECK FOR DTC

DESCRIPTION

HINT:

The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when it is activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.

INSPECTION PROCEDURE

NOTICE:

1. When "!" mark is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
   
2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (Click here).
   

1. Read the Data List according to the display on the GTS (Click here).
   
   

   Intelligent Parking Assist System / Back Guide Monitor

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Video Output Status	Status of the video output status / OK or NG	OK: Parking assist ECU is normal NG: Parking assist ECU is abnormal	-
   ROM/SUM Check	Status of the ROM/SUM check / OK or NG	OK: Parking assist ECU is normal NG: Parking assist ECU is abnormal	-
   EEPROM Status (Initial read)	Status of the EEPROM check (initial read) / OK or NG	OK: Parking assist ECU is normal NG: Parking assist ECU is abnormal	-
   RAM Check	Status of the RAM check / OK or NG	OK: Parking assist ECU is normal NG: Parking assist ECU is abnormal	-

   Result

   Result	Proceed to
   OK is displayed for all items.	A
   NG is displayed except EEPROM Status (Initial read).	A
   NG is displayed for Video Output Status	B

HINT:

1. The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when it is activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.
   
2. If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.
   

1. Use the transition of diagnosis screens (note which transition pattern occurs) to confirm if the parking assist ECU was able to properly store the information from initialization (Click here).
   

   HINT:

   The procedure to make the parking assist ECU store the vehicle information differs when the parking assist ECU has stored the information (initialized) and when the information has not been stored (not initialized).

2. Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.
   

   Condition	Procedure
   Not initialized	Parking assist ECU initialization (Click here)
   Initialized	Camera position setting (Click here) Steering angle setting (Click here)

1. Clear the DTCs (Click here).
   

2. Check for DTCs (Click here).
   

   OK:

   DTC C1611 is not output.
   

HINT:

1. If DTC C1611 is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.
   
2. If DTC C1611 is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.
   
3. If DTC C1611 is output frequently, replace the parking assist ECU even though the DTC is not output when rechecking for DTCs.