Blind Spot Monitor System How To Proceed With Troubleshooting

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. VEHICLE BROUGHT TO WORKSHOP

  2. CUSTOMER PROBLEM ANALYSIS

  3. INSPECT BATTERY VOLTAGE

  4. CHECK CAN COMMUNICATION SYSTEM*

  5. CHECK FOR DTC AND FREEZE FRAME DATA*

  6. PROBLEM SYMPTOMS TABLE

  7. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM*

  8. ADJUST, REPAIR OR REPLACE

  9. PERFORM BEAM AXIS CONFIRMATION

  10. PERFORM CONFIRMATION TEST*

Blind Spot Monitor System -- How To Proceed With Troubleshooting


HINT:
  1. Use the following procedure to troubleshoot the blind spot monitor system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
      HINT:
      If there are any scratches or impact marks on the rear bumper, perform the blind spot monitor beam axis confirmation. If any abnormalities are found, perform the blind spot monitor sensor installation condition inspection.

    NEXT


    3.INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage.

      Standard Voltage:
      11 to 14 V
      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

    NEXT


    4.CHECK CAN COMMUNICATION SYSTEM*

    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result
      Result
      		Proceed to
      CAN communication system DTCs are not output.
      		A
      CAN communication system DTCs are output (for LHD).
      		B
      CAN communication system DTCs are output (for RHD).
      		C



    		B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)

    		C.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC AND FREEZE FRAME DATA*

    1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).

    2. Record or print DTCs and freeze frame data, if necessary (Click here).

      Result
      Result
      		Proceed to
      DTCs are not output.
      		A
      DTCs are output.
      		B



    		B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table (Click here).

      Result
      Result
      		Proceed to
      Fault is not listed in Problem Symptoms Table.
      		A
      Fault is listed in Problem Symptoms Table.
      		B

      HINT:
      If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms (Click here).


    		B.
    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
    A


    7.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM*

    1. Refer to Terminals of ECU (Click here).

    2. Refer to Diagnosis System (Click here).

    3. Refer to Data List / Active Test (Click here).


    NEXT


    8.ADJUST, REPAIR OR REPLACE

      NEXT


      9.PERFORM BEAM AXIS CONFIRMATION

      1. Confirm the blind spot monitor beam axis display and perform the blind spot monitor beam axis adjustment (Click here).


      NEXT


      10.PERFORM CONFIRMATION TEST*

        NEXT

        END