Parking Assist Monitor System (W/ Side Monitor System) How To Proceed With Troubleshooting
VEHICLE BROUGHT TO WORKSHOP
INSPECT BATTERY VOLTAGE
CHECK NAVIGATION SYSTEM
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
CHECK FOR DTC*
PROBLEM SYMPTOMS TABLE
OVERALL ANALYSIS AND TROUBLESHOOTING*
ADJUST, REPAIR OR REPLACE
CONFIRMATION TEST
Parking Assist Monitor System (W/ Side Monitor System) -- How To Proceed With Troubleshooting |
- HINT:
- Use the following procedure to troubleshoot the parking assist monitor system (w/ Side Monitor System).
- *: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP |
2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage with the engine switch off.
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding.
3.CHECK NAVIGATION SYSTEM |
Refer to the navigation system (Click here).
ResultResult
| Proceed to
|
Navigation system is normal
| A
|
Navigation system is abnormal
| B
|
4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- for LHD: Click here
- for RHD: Click here
ResultResult
| Proceed to
|
CAN DTC is not output
| A
|
CAN DTC is output (for LHD)
| B
|
CAN DTC is output (for RHD)
| C
|
Check for DTCs and note any codes that are output (Click here).
Clear the DTC (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
- NOTICE:
- The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the parking assist monitor system (w/ Side Monitor System) are output, refer to Diagnostic Trouble Code Chart for the applicable system.
ResultResult
| Proceed to
|
DTC is not output
| A
|
DTC is output
| B
|
Refer to the Problem Symptoms Table (Click here).
ResultResult
| Proceed to
|
Fault is not listed in Problem Symptoms Table
| A
|
Fault is listed in Problem Symptoms Table
| B
|
| ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE |
|
|
7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here).
Terminals of ECU (Click here).
8.ADJUST, REPAIR OR REPLACE |