Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 3UR-FE ENGINE CONTROL
CAMSHAFT POSITION SENSOR - INSTALLATION
| 1. INSTALL VVT SENSOR |
Apply a light coat of engine oil to the O-ring of the VVT sensor.
- NOTICE:
When reusing the sensor, inspect the O-ring.
If the O-ring has scratches or cuts, replace the sensor.
Install the 4 sensors with the 4 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm, 7 ft.*lbf}
Connect the 4 sensor connectors.
| 2. INSTALL CAMSHAFT POSITION SENSOR |
Install the sensor with the bolt.
- Torque:
- 10 N*m{ 102 kgf*cm, 7 ft.*lbf}
- NOTICE:
When reusing the sensor, inspect the O-ring.
If the O-ring has scratches or cuts, replace the sensor.
Connect the sensor connector.
| 3. INSTALL AIR CLEANER HOSE ASSEMBLY |
Install the air cleaner hose so that the protrusion of the air cleaner cap aligns with the groove of the hose as shown in the illustration.
| *1 | Groove |
| *2 | Protrusion |
Tighten the 2 clamps.
- Torque:
- 2.5 N*m{ 25 kgf*cm, 22 in.*lbf}
Connect the vacuum hose.
Connect the No. 2 ventilation hose.
| 4. INSTALL V-BANK COVER SUB-ASSEMBLY |
Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.
| *1 | Bracket |
| *2 | Hook |
| *3 | Pin |
| *4 | Grommet |