Dtc C1337 Diameter Of The Tire Is Not Uniform

Brake. Land Cruiser. Urj200, 202 Grj200 Vdj200
Brake Control Dynamic Control Systems. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

INSPECTION PROCEDURE

CHECK TIRE SIZE

RECONFIRM DTC

DTC C1337 Diameter of the Tire is not Uniform


DESCRIPTION

The skid control ECU (master cylinder solenoid) measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.

DTC Code
DTC Detection Condition
Trouble Area
C1337
Either condition is met:
  1. The diameter of the 2 front wheels and 2 rear wheels is different.
  2. There is a wheel speed sensor fault.
  1. Speed sensor
  2. Speed sensor rotor
  3. Speed sensor circuit
  4. Tire size

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration (Click here).
HINT:
When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (Click here).
1.CHECK TIRE SIZE

  1. Check tire size and condition of all 4 wheels.

    OK:
    Condition of all 4 wheels is normal and tire size is same.


NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME SIZE
OK


2.RECONFIRM DTC

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result
    Result
    		Proceed to
    DTC is not output
    		A
    DTC is output (for LHD)
    		B
    DTC is output (for RHD)
    		C


B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)