Transfer Oil Replacement

except 1GR-FE:
Remove the 2 bolts and transfer dynamic damper.

Remove the 4 bolts and transfer heat insulator.

Remove the 7 bolts and lower transfer case protector.

Remove the filler plug and gasket.

Remove the drain plug and gasket, and drain the transfer oil.

Install a new gasket onto the drain plug and then install the plug.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

NOTICE:

1. Add oil slowly.
   
2. Add oil a little at a time, waiting several minutes between each addition of oil.
   

Wait approximately 5 minutes and check that the oil level has not changed.

Install a new gasket onto the filler plug and then install the plug.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

Install the lower transfer case protector with the 7 bolts.

Torque:

14 N*m{139 kgf*cm, 10 ft.*lbf}

Install the transfer heat insulator with the 4 bolts.

Torque:

30 N*m{306 kgf*cm, 22 ft.*lbf}

except 1GR-FE:
Install the transfer dynamic damper with the 2 bolts.

Torque:

12 N*m{122 kgf*cm, 9 ft.*lbf}