Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
Cruise Control. Land Cruiser. Urj200, 202 Grj200 Vdj200
Millimeter Wave Radar Sensor -- Installation |
- NOTICE:
- If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
| 1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
- NOTICE:
- If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).
Set beam axis to the standard position.
Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.
- Specified Condition:
- Difference between (A) and (B): 1 mm (0.0394 in.) or less
- NOTICE:
- The beam axis change mechanism may be damaged if torque exceeding the specified amount (1.5 N*m{15kgf*cm.13 in.*lbf}) is applied.
Text in Illustration *a Beam Axis Change Mechanism *b Bolt
Attach the 2 guides.
Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly.
- Torque:
- Bolt:
- 2.5 N*m{25 kgf*cm, 22 in.*lbf}
- HINT:
- Tighten the bolts and screws in the order indicated in the illustration.
Text in Illustration *a Bolt *b Screw
 |
Connect the connector.
| 2. INSTALL UPPER RADIATOR SUPPORT SEAL |
Install the upper radiator support seal with the 7 clips.
| 3. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
If the millimeter wave radar sensor has been replaced, the front of the vehicle has been repaired or modified, or the position of the beam axis change mechanism has been changed, perform adjustment. (Click here)