INSPECT ENGINE SWITCH
Engine Switch -- Inspection |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Switch Condition
| Specified Condition
|
7 (SS1) - 5 (GND)
2 (SS2) - 5 (GND)
| Not pushed
| 10 kΩ or higher
|
7 (SS1) - 5 (GND)
2 (SS2) - 5 (GND)
| Pushed
| Below 1 Ω
|
Text in Illustration*a
| Component without harness connected
(Engine Switch)
|
If the result is not as specified, replace the engine switch.
Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
- HINT:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- If the voltage is too low, the indicator will not illuminate.
- OK:
Measurement Condition
| Specified Condition
|
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND)
| Illuminates (illumination of lettering)
|
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 5 (GND)
| Illuminates (green)
|
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 5 (GND)
| Illuminates (amber)
|
Text in Illustration*1
| Indicator
| -
| -
|
*a
| Component without harness connected
(Engine Switch)
| -
| -
|
If the result is not as specified, replace the engine switch.
