Rear Crankshaft Oil Seal Installation

Using SST and a hammer, tap in a new oil seal as shown in the illustration.

SST

09223-56010

Standard depth A:

2.7 to 3.7 mm (0.106 to 0.147 in.)

NOTICE:

1. Keep the lip free from foreign matter.
   
2. Do not tap on the seal at an angle.
   
3. Make sure that the lip of the oil seal is properly installed.
   

Using a wrench, hold the crankshaft.

Install the rear crankshaft balancer weight.

Text in Illustration

Engine Side

HINT:

1. Align the pin hole of the rear crankshaft balancer weight with the pin of the crankshaft.
   
2. As the rear crankshaft balancer weight is not reversible, be sure to install it so that it is facing in the direction shown in the illustration.
   

Install the drive plate and ring gear and rear drive plate spacer with 8 new bolts.

Text in Illustration

*1	Drive Plate and Ring Gear
*2	Rear Drive Plate Spacer
	Automatic Transmission Side

HINT:

As the drive plate and ring gear and rear drive plate spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

Torque:

182 N*m{1856 kgf*cm, 134 ft.*lbf}

Temporarily install the flywheel with 8 new bolts.

NOTICE:

1. Align the crankshaft knock pin and flywheel knock pin hole.
   
2. Do not strike or damage the flywheel installation bolts. Be sure to handle them carefully.
   
3. Make sure there is no oil on the bolts.
   

Using a wrench, hold the crankshaft.

Uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

Torque:

182 N*m{1856 kgf*cm, 134 ft.*lbf}

Insert SST into the clutch disc, then insert the clutch disc into the flywheel.

SST

09301-00120

NOTICE:

Take care not to insert the clutch disc in the wrong direction.

Align the matchmark on the clutch cover with the one on the flywheel.

In the order shown in the illustration, temporarily install the 8 bolts starting from the bolt located near the knock pin on the top.

Check that the disc is in the center by lightly moving SST up and down, and left and right.

SST

09301-00120

Evenly tighten the bolts by following the order shown in the illustration.

Torque:

39 N*m{400 kgf*cm, 29 ft.*lbf}

Connect the cables to the negative (-) main battery and sub-battery terminals.