Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
1Vd-Ftv Engine Mechanical. Land Cruiser. Urj200, 202 Grj200 Vdj200
Front Crankshaft Oil Seal -- Installation |
| 1. INSTALL FRONT CRANKSHAFT OIL SEAL |
Apply engine oil to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal as shown in the illustration.
- SST
- 09316-12010
09950-70010(09951-07100)
09950-60020(09951-00890)
- Standard depth A:
- 0.6 to 1.4 mm (0.0236 to 0.0551 in.)
- NOTICE:
- Make sure that the lip of the oil seal is properly installed.
 |
| 2. INSTALL CRANKSHAFT PULLEY SUB-ASSEMBLY |
- NOTICE:
- This procedure is intended for removal/installation of the crankshaft pulley only. Do not use this procedure for removal/installation of the flywheel or the drive plate and ring gear.
Align the crankshaft pulley and the crankshaft knock pin, and temporarily install the crankshaft pulley with the 3 bolts.
Text in Illustration *1 Service Hole *2 Protrusion
 |
Install the 2 bolts to the bolt holes of the crankshaft rear side.
Using a bar, turn the crankshaft until the crankshaft pulley service hole is a little to the right of bottom dead center.
Install a 14 mm x 1.5 pitch service bolt with a length of 70 mm or more to the crankshaft pulley service hole, and hold the crankshaft using the timing chain cover protrusion.
Uniformly tighten the 3 bolts in 2 passes in the order shown in the illustration.
- Torque:
- 115 N*m{1168 kgf*cm, 84 ft.*lbf}
 |
Remove the service bolt.
| 3. INSTALL RADIATOR ASSEMBLY |