Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
1Vd-Ftv Engine Control. Land Cruiser. Urj200, 202 Grj200 Vdj200
Mass Air Flow Meter (W/O Dpf) -- Inspection |
| 1. INSPECT MASS AIR FLOW METER |
Check the output voltage.
Apply battery voltage across terminals 1 (+B) and 2 (E2G).
- NOTICE:
- While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG), and negative (-) tester probe to terminal 2 (E2G).
Blow air into the MAF meter, and check that the voltage fluctuates.
If the result is not as specified, replace the MAF meter.
Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.
- OK:
- There is no foreign material.
 |
Check the IAT sensor.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 4 (THA) - 5 (E2) -20°C (-4°F) 12.5 to 16.9 kΩ 20°C (68°F) 2.19 to 2.67 kΩ 60°C (140°F) 0.5 to 0.68 kΩ