Front Power Seat Motor Assembly (For Reclining) Installation

Temporarily install the power seat motor assembly (for Reclining) with the 3 bolts.

Install the reclining rod.

Attach the 6 claws to install the push nut to the reclining rod.

Using a 4 mm socket hexagon wrench, tighten the 3 bolts.

Torque:

4.5 N*m{46 kgf*cm, 40 in.*lbf}

Attach the 8 hooks to install the seatback spring.

Connect the connector.

Attach the guide to install the reclining adjuster inside cover LH.

Install the screw.

Attach the claw to install the reclining adjuster inside cover LH.

Install the screw.

Install the No. 1 seatback cloth.

Install the separate type front seatback pad.

Using hog ring pliers, attach the strap of the separate type front seatback cover to the separate type front seatback pad with new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, avoid wrinkling the cover.
   

Attach the 4 claws to install the 2 front seat headrest supports.

Pass the straps of the separate type front seatback cover through the holes of the separate type front seatback pad.

Using hog ring pliers, attach the strap of the separate type front seatback cover together with the No. 1 seatback cloth to the separate type front seatback spring assembly with new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, avoid wrinkling the cover.
   

Pass the No. 2 seat wire through the hole of the separate type front seatback cover.

Using hog ring pliers, attach the wires at the bottom of the separate type front seatback cover with new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, avoid wrinkling the cover.
   

Connect the No. 2 seat wire connector and attach the wire harness clamp.

Pass the wire harness of the front seat inner belt assembly below the claw and into the front seat inner cushion shield LH.

Attach the claw to temporarily install the front seat inner cushion shield LH.

NOTICE:

Make sure that the wire harness of the front seat inner belt assembly is not being pinched inside the front seat inner cushion shield.

Attach the guide and claw.

NOTICE:

Make sure that the wire harness of the front seat inner belt assembly is not being pinched inside the front seat inner cushion shield.

Install the screw.

Attach the claw and guide to install the front seat cushion shield LH with the front inner No. 1 seat cushion shield LH.

Install the 3 screws.

Install the 2 screws.

Attach the 4 claws to install the slide and vertical power seat switch knob.

Attach the 2 claws to install the reclining power seat switch knob.