Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Brake Control Dynamic Control Systems. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Steering Angle Sensor (W/ Vsc) -- Installation |
| 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY |
- NOTICE:
- Do not replace the spiral cable with the battery connected and the ignition switch ON.
- Do not rotate the spiral cable with the battery connected and the ignition switch ON.
- Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
- Do not remove the steering angle sensor from the spiral cable.
| 2. INSTALL STEERING COLUMN UPPER COVER |
Attach the claw to install the upper cover.
| 3. INSTALL STEERING COLUMN LOWER COVER |
Install the lower cover with the 3 screws.
| 4. ADJUST SPIRAL CABLE |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.
- NOTICE:
- Do not use the airbag wire harness to turn the spiral cable sub-assembly.
 |
Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.
Text in Illustration *a Mark - NOTICE:
- Do not turn the spiral cable with steering sensor by the airbag wire harness.
- HINT:
- The spiral cable with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.
 |
| 5. INSTALL STEERING WHEEL ASSEMBLY |
| 6. INSTALL STEERING PAD |
for 4 Spoke:
(HILUX_TGN26 RM0000033RR08KX_01_0026.html)
for 3 spoke:
(HILUX_TGN26 RM0000033RR08KX_01_0028.html)
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR3009X.html).
| 8. CHECK SRS WARNING LIGHT |