Anti-Lock Brake System Ts And Cg Terminal Circuit
Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU)
ANTI-LOCK BRAKE SYSTEM - TS and CG Terminal Circuit |
DESCRIPTION
The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.- HINT:
- Change to Test Mode (signal check) by connecting terminals TS and CG of the DLC3, and turning the ignition switch from off to ON.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Before disconnecting the connector, make sure that there are no problems with the connection.
- After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
| 1.CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
G18-4 (CG) - Body ground
| Always
| Below 1 Ω
|
G18-12 (TS) - A13-15 (TS)
| Always
| Below 1 Ω
|
A13-15 (TS) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
