Ig2 Relay On-Vehicle Inspection

Двигатель. Toyota Rav4. Aca30, 33, 38 Ala30
Система Управления Двигателем 2Az-Fe. Toyota Rav4. Aca30, 33, 38 Ala30

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE IG2 RELAY

  3. INSPECT IG2 RELAY

  4. INSTALL IG2 RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Ig2 Relay -- On-Vehicle Inspection



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE IG2 RELAY

  1. Remove the No. 1 engine room relay block cover.

  1. Remove the IG2 relay from the engine room relay block.



3. INSPECT IG2 RELAY


    Toyota Rav4. Aca30, 33, 38 Ala30.Система Управления Двигателем 2Az-Fe.Система Sfi.Ig2 Relay On-Vehicle Inspection

  1. Measure the resistance of the IG2 relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)
    If the result is not as specified, replace the relay.


4. INSTALL IG2 RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL