Двигатель. Toyota Rav4. Aca30, 33, 38 Ala30
Система Управления Двигателем 2Ad-Ftv. Toyota Rav4. Aca30, 33, 38 Ala30
Crankshaft Position Sensor -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- ПРЕДОСТЕРЕЖЕНИЕ:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 ENGINE COVER |
Detach the 4 clips and remove the engine cover.
 |
| 3. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts, 12 clips and engine under cover.
| 4. REMOVE ENGINE UNDER COVER RH |
Remove the 2 clips and engine under cover.
| 5. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH |
 |
Remove the 4 bolts and reinforcement.
| 6. REMOVE FAN AND GENERATOR V BELT |
Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
- Специальный инструмент (SST):
- 09216-42010
- ПРИМЕЧАНИЕ:
- Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.
 |
| 7. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
Remove the front drive shaft (see page RAV4_ACA30 RM00000226Q000X.html).
| 8. REMOVE GENERATOR ASSEMBLY |
Disconnect the generator connector.
 |
Remove the terminal cap.
Remove the nut and bolt, and disconnect the generator wire.
Remove the 3 bolts and generator.
| 9. REMOVE CRANKSHAFT POSITION SENSOR |
Disconnect the sensor connector.
 |
Disconnect the sensor connector from the bracket.
Disconnect the sensor wire harness clamp.
Remove the bolt and sensor.