Engine Hybrid System. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
2Kd-Ftv Lubrication. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Engine Oil Cooler -- Removal |
- NOTICE:
- When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
- When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
- After removing the injection pipes, clean them with a brush and compressed air.
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
| 2. DRAIN ENGINE COOLANT |
- CAUTION:
- Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the radiator drain cock plug.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.
Drain the coolant by removing the radiator reservoir cap and, using a wrench, remove the vent plug.
 |
Loosen the cylinder block drain cock plug.
Text in Illustration *1 Radiator Reservoir *2 Radiator Reservoir Cap *3 Vent Plug *4 Cylinder Block Drain Cock Plug *5 Radiator Drain Cock Plug - -
| 3. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
- Torque:
- 34 N*m{347 kgf*cm, 25 ft.*lbf}
| 4. REMOVE FUEL SUPPLY PUMP ASSEMBLY |
- w/ DPF: (HILUX_TGN26 RM0000014FO01PX.html)
- w/o DPF: (HILUX_TGN26 RM0000014FO01SX.html)
| 5. REMOVE COMMON RAIL ASSEMBLY |
- w/ DPF: (HILUX_TGN26 RM0000044W300GX.html)
- w/o DPF: (HILUX_TGN26 RM000002SY5023X.html)
| 6. REMOVE STARTER ASSEMBLY |
- for Denso Made: (HILUX_TGN26 RM0000013XL03EX.html)
- for Bosch Made: (HILUX_TGN26 RM0000013XL03FX.html)
| 7. REMOVE OIL FILTER SUB-ASSEMBLY |
Using SST, remove the oil filter.
- SST
- 09228-07501
- HINT:
- Insert the drain hose in the oil filter. Put the disposal container beneath the drain hose to collect the oil from the oil filter.
 |
| 8. REMOVE OIL COOLER COVER SUB-ASSEMBLY |
Disconnect the oil pressure switch connector.
Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.
Remove the 13 bolts, oil cooler cover and gasket.
 |
| 9. REMOVE OIL COOLER ASSEMBLY |
Loosen the 4 nuts.
 |
Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.
Remove the 4 nuts, oil cooler and 2 gaskets.