Theft Deterrent System (W/ Intrusion Sensor) - How To Proceed With Troubleshooting

Lexus IS250 IS220d GSE20 ALE20 - THEFT DETERRENT


THEFT DETERRENT SYSTEM (w/ Intrusion Sensor) - HOW TO PROCEED WITH TROUBLESHOOTING

  • HINT:
Use this procedure to troubleshoot the theft deterrent system.
The intelligent tester should be used in step 3.

1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.CUSTOMER PROBLEM ANALYSIS

Interview the customer to confirm the trouble

NEXT
3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)

Use the intelligent tester to check for normal function of the multiplex communication system.


(ECU unconnected, communication line malfunctioning) Without code output, proceed to A.

(ECU unconnected, communication line malfunctioning) With code output, proceed to B.

B.
Go To MULTIPLEX COMMUNICATION SECTION
A
4.DTC CHECK

Check for DTC and note any codes that are output.

Delete the DTC.

Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.


If the DTC does not reoccur, proceed to A.

If the DTC reoccurs, proceed to B.

B.
Go To DTC CHART
A
5.SYMPTOM SIMULATION
NEXT
6.PROBLEM SYMPTOMS TABLE

If the fault is not listed on the problem symptoms table, proceed to A.

If the fault is listed on the problem symptoms table, proceed to B.

B.
Go to step 7
A
7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM

Terminals of ECU

On-vehicle inspection

8.ADJUST, REPAIR OR REPLACE
NEXT
9.CONFIRMATION TEST
NEXT
END