Crankshaft Position Sensor Installation

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

1. When reusing the crankshaft position sensor, inspect the O-ring.
   
2. If the O-ring has scratches or cuts, replace the crankshaft position sensor.
   

Install the crankshaft position sensor with the bolt.

Torque:

10 N*m{102 kgf*cm, 7 ft.*lbf}

Connect the crankshaft position sensor connector.

Temporarily install the compressor with the bolt labeled A.

Install the compressor completely by tightening the 4 bolts in the order shown in the illustration.

Torque:

25 N*m{250 kgf*cm, 18 ft.*lbf}

NOTICE:

In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.

Connect the compressor connector.

Connect the suction hose with the 2 bolts.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}