Rear Spoiler (For Sedan) Installation

Vehicle Exterior. Yaris. Ncp93, 131
Exterior Panels Trim. Yaris. Ncp93, 131

  1. INSTALL REAR SPOILER PROTECTOR SIDE LH

  2. INSTALL REAR SPOILER PROTECTOR SIDE RH

  3. INSTALL REAR SPOILER SUB-ASSEMBLY

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Rear Spoiler (For Sedan) -- Installation



1. INSTALL REAR SPOILER PROTECTOR SIDE LH


Yaris. Ncp93, 131
NOTICE:
Follow these procedures only when replacing the protector.

  1. Apply a new rear spoiler protector to the rear spoiler installation surface as shown in the illustration.



2. INSTALL REAR SPOILER PROTECTOR SIDE RH
HINT:
Use the same procedure as for the LH side.


3. INSTALL REAR SPOILER SUB-ASSEMBLY


  1. Clean the rear spoiler (When reusing the rear spoiler).

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the rear spoiler while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using non-residue solvent, clean the rear spoiler.



      4. Yaris. Ncp93, 131

    4. Apply new double-sided adhesive tape to the rear spoiler installation surface as shown in the illustration.

  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the luggage compartment door panel while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using non-residue solvent, clean the attachment surface.



    Yaris. Ncp93, 131

  1. Install the wire harness into the luggage compartment door panel hole.

  1. Engage the 2 clips and install the rear spoiler.

  1. Remove the protective tape.



    Yaris. Ncp93, 131

  1. Tighten the 2 bolts.

  1. Connect the center stop light connector.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N*m{55 kgf*cm, 48 in.*lbf}