Rear Door Speaker (For Hatchback) Removal

Disengage the 2 clips and claw.

Disengage the guide and remove the rear door frame garnish.

Insert a clip remover between the plate and front door trim board.

Turn the handle with the clip remover inserted, as shown in the illustration.

Remove the front door window regulator handle and clip.

Remove the window regulator handle plate.

Using a moulding remover, disengage the 9 claws and 3 guides.

Disconnect the connector and remove the rear armrest base upper panel.

Using a moulding remover, disengage the 5 claws and 2 guides and remove the rear armrest base upper panel.

Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.

Remove the 3 screws.

Disengage the 7 clips.

Disconnect the rear door lock remote control cable assembly and the rear door inside locking cable assembly and remove the rear door trim board.

Disconnect the connector.

Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the rear door panel.

Operate the drill around the rivet head circumference and cut out the flange.

CAUTION:

Be careful. The cut rivet is very hot.

NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

After drilling out the flange, continue drilling to push out the shards on the drill.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.