Parking Brake Cable (For Sedan) Removal

Disengage the 2 claws and 2 clips and remove the instrument panel finish panel.

Shift the shift lever into the N position.

Disengage the 5 clips and the claw and remove the upper console panel.

Disengage the 3 clips and 3 claws.

Disconnect the connector and remove the rear upper console panel.

Remove the console box carpet.

Disconnect the clamp.

Remove the 2 bolts and 2 screws.

Disengage the 4 claws and remove the rear console box.

Release the parking brake and remove the rear brake drum.
If the rear brake drum cannot be removed easily, perform the following procedure.

Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

Using another screwdriver, contract the brake shoe by turning the adjusting bolt.

Using SST, separate the shoe return spring from the front brake shoe.

SST

09703-30010

NOTICE:

Do not damage the wheel cylinder boot.

Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

SST

09718-00010

Remove the tension spring.

Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.

Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

SST

09718-00010

Using needle-nose pliers, separate the parking brake cable.

Remove the 2 nuts and remove the heat insulator.

Pinch and remove the clip as shown in the illustration.

Remove the bolt and fuel tank cover vent case.

Loosen the lock nut and the adjusting nut.

Disconnect the cable end from the equalizer.

Remove cable clamp A from the body.

Remove the 4 bolts.

Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.

Remove the bolt and remove the parking brake cable from the backing plate.

Remove the cable clamp B from the parking brake cable.

HINT:

Replace the cable clamp B with a new one when installing the parking brake cable.