Parking Brake System (For Sedan) Adjustment

Provisionally install the 2 hub nuts.

Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.

Using a screwdriver, release the adjuster 12 notches.

Install the hole plug.

Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

Parking brake lever travel:

6 to 9 clicks at 200 N (20 kgf, 45 lbf)

Disengage the 2 claws and 2 clips and remove the instrument panel finish panel.

Shift the shift lever into the N position.

Disengage the 5 clips and the claw and remove the upper console panel.

Disengage the 3 clips and 3 claws.

Disconnect the connector and remove the rear upper console panel.

Remove the console box carpet.

Disconnect the clamp.

Remove the 2 bolts and 2 screws.

Disengage the 4 claws and remove the rear console box.

Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

Parking brake lever travel:

6 to 9 clicks at 200 N (20 kgf, 45 lbf)

Tighten the lock nut.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}

Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

Check whether the parking brake drags or not.

When operating the parking brake lever, check that the brake warning light illuminates.

Standard:

Brake warning light always illuminates at the first click.

Engage the 4 claws and install the rear console box.

Install the 2 bolts and 2 screws.

Connect the clamp.

Install the console box carpet.

Connect the connector.

Engage the 3 clips and 3 claws and install the rear upper console panel.

Engage the 5 clips and the claw and install the upper console panel.

Engage the 2 claws and 2 clips and install the instrument panel finish panel.