Rear Axle Hub (For Hatchback) Installation

Install the axle hub and bearing onto the axle beam with the 4 bolts.

Torque:

90 N*m{918 kgf*cm, 66 ft.*lbf}

Install the dust cover and the axle hub and bearing onto the axle beam with the 4 bolts.

Torque:

90 N*m{918 kgf*cm, 66 ft.*lbf}

Using a dial indicator, check the backlash near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)

Using a dial indicator, check the backlash near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)

Using a dial indicator, check the runout of the surface of the axle hub.

Maximum:

0.07 mm (0.00276 in.)

Using a dial indicator, check the runout of the surface of the axle hub.

Maximum:

0.07 mm (0.00276 in.)

Install the skid control sensor wire LH onto the rear axle beam assembly with the nut.

Torque:

6.0 N*m{61 kgf*cm, 53 in.*lbf}

Connect the skid control sensor wire LH connector.

Align the matchmarks of the rear disc and axle hub and install the rear disc.

NOTICE:

When replacing the disc with a new one, select the installation position where the rear disc has minimal runout.

Install the rear disc brake cylinder mounting to the axle beam with the 2 bolts.

Torque:

57 N*m{585 kgf*cm, 42 ft.*lbf}

Install the 2 rear disc brake pads to the rear disc brake cylinder mounting.

NOTICE:

There should be no oil or grease on the friction surfaces of the disc brake pads or the rear disc.

To compensate for pad wear when reusing the pad, use SST to push and turn the piston (LH side: counterclockwise, RH side: clockwise) to the position where the protrusion on the pad lines up properly with the piston groove.

SST

09719-12010(09719-01030)

HINT:

Place the disc between the 2 brake pads and determine the piston return value.

Hold the rear disc brake pad guide pin, and install the rear disc brake cylinder assembly to the rear disc brake cylinder mounting with the 2 bolts.

Torque:

34 N*m{350 kgf*cm, 25 ft.*lbf}

Insert the parking brake cable into the disc brake cylinder and engage the clip claws of the parking brake cable to the rear disc brake cylinder guide.

Connect the cable end to the rear disc brake cylinder operation lever.