Power Window Regulator Motor (For Rear Door) Removal

Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel.

Using a moulding remover, disengage the 2 clips and 7 claws.

Disconnect the connector and remove the rear door armrest upper base panel.

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and disconnect the door armrest cap.

Remove the 2 screws.

Using a clip remover, disengage the 8 clips.

Disengage the 4 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.

Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

Disconnect the rear door lock remote control cable and rear door inside locking cable, and remove the rear door inside handle sub-assembly.

Remove the rear door inner glass weatherstrip from the rear door panel.

Remove the 2 screws and the rear door trim bracket.

w/ Power door lock:

1. Disconnect the connector.
   

Remove the rear door service hole cover.

HINT:

Remove any remaining butyl tape from the door.

Remove the upper part of the rear door weatherstrip to the extent that allows.

Remove the rear door glass run.

Remove the 2 bolts, screw, and the rear door window division bar sub-assembly.

Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.

Remove the rear door quarter window glass from the rear door quarter window weatherstrip.

Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

NOTICE:

Do not damage the door glass.

Disconnect the connector.

Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall and cause damage.

Remove the 3 bolts.

Remove the rear door window regulator sub-assembly and the rear power window regulator motor assembly as a unit.

Remove the temporary bolt from the rear door window regulator sub-assembly.

Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the rear power window regulator motor assembly to move the lift arm to the position shown in the illustration.

Using a "TORX" socket wrench (T25), remove the 3 screws and the rear power window regulator motor assembly.