Room Temperature Sensor Installation

Engage the 2 claws and install the room temperature sensor.

Engage the air hose.

Connect the connector.

Engage the 3 claws and clip, and install the No. 1 switch hole base.

Connect the connector.

Engage the 3 claws and install the No. 1 switch hole base.

Engage the guide, claw and 3 clips, and install the instrument cluster finish panel assembly.

Remove the applied protective tape on the steering column cover.

Engage the 2 claws and 2 clips, and then install the instrument panel finish panel end LH.

Engage the 3 claws and clip, and then install the lower instrument panel finish panel LH.

Engage the claw and the 2 pins, and install the upper steering column cover.

Engage the 2 claws to install the lower steering column cover.

Engage the 4 claws.

Engage the claw.

HINT:

Press the area around the claw to engage it.

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Rotate the spiral cable counterclockwise slowly by hand until it stops.

NOTICE:

Do not turn the spiral cable using the airbag wire harness.

Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable using the airbag wire harness.

HINT:

The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

Engage the 5 claws, 2 clips and 2 guides.

Install the lower instrument panel finish panel sub-assembly with the 2 screws <B>.

Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system (COROLLA_ZRE142 RM0000016F5071X.html).