Lumbar Support Adjuster Assembly Installation

Install the lumbar support adjuster assembly with the 2 screws.

Connect the connector.

Temporarily install the front seatback cover with pad to the front seat frame assembly with adjuster.

Engage the 4 claws and install the 2 front seat headrest supports.

Install the front seatback cover bracket with the nut.

Torque:

5.5 N*m{56 kgf*cm, 49 in.*lbf}

NOTICE:

1. For vehicles with side airbags, the side airbags may not be activated normally unless the front seatback cover is securely installed.
   
2. Check that the strap is not twisted after installing the bracket.
   
3. Install the bracket securely.
   

Using hog ring pliers, install 3 new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, take care to minimize wrinkles as much as possible.
   

Using hog ring pliers, install 4 new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, take care to minimize wrinkles as much as possible.
   

Insert the guide and temporarily install the front seat cushion inner shield as shown in the illustration.

Engage the claw and the 2 guides.

Install the front seat cushion inner shield with the screw.

Install the front seat inner belt assembly with the nut.

Torque:

41 N*m{420 kgf*cm, 30 ft.*lbf}

NOTICE:

Do not overlap the anchor part of the seat belt and protruding part of the seat adjuster.

Connect each connector and clamp.

Connect the connector to the front power seat lumbar switch.

Engage the claw and the guide.

Install the front seat cushion shield assembly with the 5 screws.

Install the 2 hooks.

Engage the 2 claws and install the slide and vertical power seat switch knob.

Engage the 2 claws and install the reclining power seat switch knob.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.

Connect the connectors under the seat.

Connect the cable to the negative (-) battery terminal.

Temporarily install the front seat assembly with the 4 bolts.

Operate the power seat switch knob and move the seat to the rearmost position.

Tighten the 2 bolts on the front side of the seat.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

HINT:

Tighten the bolts in the order indicated in the illustration.

Operate the power seat switch knob and move the seat to the foremost position.

Tighten the 2 bolts on the rear side of the seat.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

HINT:

Tighten the bolts in the order indicated in the illustration.

Engage the 2 claws and install the inner seat track cover.

Engage the 2 claws and install the outer seat track cover.

Inspect the power seat operation.