Entry Lock And Unlock Switch Removal

Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel.

Using a moulding remover, disengage the 2 clips and 6 claws.

Disconnect the connector and remove the front armrest upper base panel.

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and disconnect the door armrest cap.

Remove the 2 screws.

Using a clip remover, disengage the 10 clips.

Disengage the 5 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

Disconnect the front door lock remote control cable and front door inside locking cable, and remove the front door inside handle sub-assembly.

Remove the 2 screws and the front door trim bracket.

w/ Power door lock:

1. Disconnect the connector.
   

Remove the front door service hole cover.

HINT:

Remove any remaining butyl tape from the door.

Remove the hole plug.

Using a "TORX" socket wrench (T30), loosen the screw and remove the front door outside handle cover and the door lock key cylinder as a unit.

HINT:

The screw cannot be removed because it is integrated into the front door outside handle frame sub-assembly.

Using a screwdriver, disengage the 2 claws and remove the front door outside handle cover.

Disconnect the connector.

Remove the front door outside handle assembly as shown in the illustration.