Front Door Lock Removal

Using a clip remover, remove the snap ring.

Remove the front door window regulator handle assembly and front door regulator inside handle plate.

Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel.

Using a moulding remover, disengage the 2 clips and 6 claws, and remove the front armrest upper base panel.

w/ Power Door Lock:

1. Disconnect the connector.
   

Using a moulding remover, disengage the 2 clips and 6 claws.

Disconnect the connector and remove the front armrest upper base panel.

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and disconnect the door armrest cap.

Remove the 2 screws.

Using a clip remover, disengage the 10 clips.

Disengage the 5 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

Disconnect the front door lock remote control cable and front door inside locking cable, and remove the front door inside handle sub-assembly.

Remove the front door inner glass weatherstrip from the front door panel.

Remove the 2 screws and the front door trim bracket.

w/ Power door lock:

1. Disconnect the connector.
   

Remove the front door service hole cover.

HINT:

Remove any remaining butyl tape from the door.

Connect the cable to the negative (-) battery terminal.

Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.

Disconnect the cable from the negative (-) battery terminal and power window regulator master switch assembly.

Remove the 2 bolts.

NOTICE:

After the bolts are removed, do not allow the door glass to fall.

Remove the front door glass sub-assembly as shown in the illustration.

NOTICE:

Do not damage the door glass.

Remove the 2 bolts.

Disengage the 2 guides and remove the front door No. 2 stiffener cushion.

Remove the front door glass run.

Remove the bolt and the front door rear lower frame sub-assembly as shown in the illustration.

Remove the hole plug.

Using a "TORX" socket wrench (T30), loosen the screw and remove the front door outside handle cover and the door lock key cylinder as a unit.

HINT:

The screw cannot be removed because it is integrated into the front door outside handle frame sub-assembly.

Using a screwdriver, disengage the 2 claws and remove the front door outside handle cover.

Using a "TORX" socket wrench (T30), remove the 3 screws.

Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.

Using a "TORX" socket wrench (T30), remove the 3 screws.

Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.

Remove the door lock wiring harness seal from the front door lock assembly.

Remove the front door lock remote control cable assembly.

Remove the front door lock remote control cable assembly.

Remove the front door inside locking cable assembly.

Using a screwdriver, disengage the 3 claws.

HINT:

Tape the screwdriver tip before use.

Remove the front door inside locking cable assembly.