Anti-Lock Brake System Ts And Cg Terminal Circuit
Brake. Corolla. Zre142 Aze141
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TS of DLC3)
CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
CHECK HARNESS AND CONNECTOR (TS of DLC3 - BODY GROUND)
ANTI-LOCK BRAKE SYSTEM - TS and CG Terminal Circuit |
DESCRIPTION
In Test Mode (signal check), a malfunction in a speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TS of DLC3) |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A51-32 (TS) - E11-12 (TS)
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 2.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E11-4 (CG) - Body ground
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 3.CHECK HARNESS AND CONNECTOR (TS of DLC3 - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E11-12 (TS) - Body ground
| Always
| 10 kΩ or higher
|
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (COROLLA_ZRE142 RM000000XHN0DVX.html).
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
