INSTALL FRONT STABILIZER BAR

INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

INSTALL FRONT NO. 1 STABILIZER BRACKET LH

INSTALL FRONT NO. 1 STABILIZER BRACKET RH

INSTALL FRONT NO. 2 STABILIZER BRACKET LH

INSTALL FRONT NO. 2 STABILIZER BRACKET RH

INSTALL FRONT STABILIZER LINK ASSEMBLY LH

INSTALL FRONT STABILIZER LINK ASSEMBLY RH

CONNECT FRONT HEIGHT CONTROL SENSOR LINK ASSEMBLY

INSTALL REAR ENGINE UNDER COVER LH

INSTALL REAR ENGINE UNDER COVER RH

INSTALL ENGINE UNDER COVER LH

INSTALL FRONT WHEEL

INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Install the front stabilizer bar to the vehicle.

• NOTICE:

• The identification mark must be on the right side of the vehicle when installing the front stabilizer bar.

Install the 2 front No. 1 stabilizer bar bushings as shown in the illustration.

• NOTICE:

• Be sure to install the front No. 1 stabilizer bar bushings so that the cutouts face the front of the vehicle.

Press the front No. 1 stabilizer bracket LH against the frame toward the outside of the vehicle and temporarily tighten bolt A.

Install bolt B, fully tighten bolt A, and then install bolts C and D.

Install the skid control sensor wire clamp to the front No. 1 stabilizer bracket LH.

• Torque:
• 49 N*m{ 500 kgf*cm, 36 ft.*lbf}

Install the front No. 2 stabilizer bracket LH on the vehicle with the 2 bolts.

• Torque:
• 49 N*m{ 500 kgf*cm, 36 ft.*lbf}

Install the front stabilizer link assembly LH with the 2 nuts.

• Torque:
• 84 N*m{ 856 kgf*cm, 62 ft.*lbf}

• HINT:

• If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

Install the engine under cover LH with the bolt.