Tire Pressure Warning Receiver Installation

Connect the connector.

Install the tire pressure warning antenna and receiver with the bolt.

Torque:

7.5 N*m{76 kgf*cm, 66 in.*lbf}

HINT:

Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning antenna and receiver.

Engage the 2 guides and 4 clips, and install the roof side inner garnish assembly LH.

Engage the 2 guides and 2 claws, and install the roof side inner garnish board LH.

Engage the 2 claws, 2 clips and guide, and install the rear seat side garnish LH.

for TMC Made:

1. Align the alignment mark (pink) on the weatherstrip and the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
   

   NOTICE:

   After installation, check that the corners fit correctly.

for TMMC Made:

1. Align the alignment mark (red) on the weatherstrip and the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
   

   NOTICE:

   After installation, check that the corners fit correctly.

Engage the 6 claws and install the rear door scuff plate LH.

Place the rear seatback assembly LH in the cabin.

NOTICE:

Be careful not to damage the vehicle body.

Install the rear seatback assembly LH with the 2 bolts.

Torque:

18 N*m{184 kgf*cm, 13 ft.*lbf}

Install the 2 rear seatback clips.

Attach the rear hook of the seat cushion to the seatback.

Attach the 2 front hooks of the seat cushion to the vehicle body.

Confirm that the seat cushion is firmly installed.

NOTICE:

When installing the seat cushion, make sure that the seat belt buckle is not under the seat cushion.