Engine Hybrid System. Corolla. Zre142 Aze141
2Az-Fe Starting. Corolla. Zre142 Aze141
Ignition Switch -- Installation |
| 1. INSTALL IGNITION SWITCH ASSEMBLY |
Install the ignition switch with the 2 screws.
 |
Connect the connector.
 |
| 2. INSTALL UPPER STEERING COLUMN COVER |
Engage the claw and the 2 pins, and install the upper steering column cover.
 |
| 3. INSTALL LOWER STEERING COLUMN COVER |
- NOTICE:
- If the lower steering column cover is installed in the incorrect order, it will not be possible to assemble the lower steering column cover.
Engage the 2 claws to install the lower steering column cover.
 |
Engage the 4 claws.
 |
Engage the claw.
- HINT:
- Press the area around the claw to engage it.
 |
| 4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Engage the 5 claws, 2 clips and 2 guides.
 |
Install the lower instrument panel finish panel sub-assembly with the 2 screws <B>.
 |
| 5. ADJUST SPIRAL CABLE |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Rotate the spiral cable counterclockwise slowly by hand until it stops.
- NOTICE:
- Do not turn the spiral cable using the airbag wire harness.
 |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
- NOTICE:
- Do not turn the spiral cable using the airbag wire harness.
- HINT:
- The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
 |
| 6. INSTALL STEERING WHEEL ASSEMBLY |
- HINT:
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- HINT:
| 8. INSPECT STEERING PAD |
Make sure that the horn sounds.
- HINT:
- If the horn does not sound, inspect the horn system (COROLLA_ZRE142 RM0000016F5071X.html).
| 9. INSPECT SRS WARNING LIGHT |
- HINT: