Rear View Monitor System How To Proceed With Troubleshooting

Body Electrical. Camry. Acv40 Gsv40
Park Assist Monitoring. Camry. Acv40 Gsv40

  1. VEHICLE BROUGHT TO WORKSHOP

  2. CUSTOMER PROBLEM ANALYSIS

  3. INSPECT BATTERY VOLTAGE

  4. PROBLEM SYMPTOM CONFIRMATION

  5. SYMPTOM SIMULATION

  6. CHECK DTC

  7. PROBLEM SYMPTOMS TABLE

  8. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

  9. ADJUST, REPAIR OR REPLACE

  10. CONFIRMATION TEST

Rear View Monitor System -- How To Proceed With Troubleshooting




1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE
        Standard Voltage:
        11 to 14 V
        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION
        Result
        Result
        		Proceed to
        Symptom does not occur
        		A
        Symptom occurs
        		B


      		B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK DTC

        1. Check for DTCs and note any codes that are output (CAMRY_ACV40 RM000003Z28005X.html).

        2. Clear the DTC (CAMRY_ACV40 RM000003Z28005X.html).

        3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

          NOTICE:
          The navigation receiver assembly may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
          System
          		Proceed to
          Navigation System
          		CAMRY_ACV40 RM0000011BO042X.html
          Result
          Result
          		Proceed to
          DTC is not output
          		A
          DTC is output
          		B


        		B.
        Go to step 9
        A


        7.PROBLEM SYMPTOMS TABLE

        1. Refer to Problem Symptoms Table (Link).

          Result
          Result
          		Proceed to
          Fault is not listed in Problem Symptoms Table
          		A
          Fault is listed in Problem Symptoms Table
          		B



        		B.
        Go to step 9
        A


        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

        1. Refer to Terminals of ECU (CAMRY_ACV40 RM0000013ZZ031X.html).


        NEXT


        9.ADJUST, REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END