Entry Lock And Unlock Switch Installation

Insert the front end of the front door outside handle assembly into the front door outside handle frame.

Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Slide the front door outside handle assembly to the front of the vehicle to install it.

Connect the connector.

Engage the 2 claws to install the front door outside handle cover to the front door lock cylinder.

Install the front door lock cylinder.

HINT:

Make sure that the front door lock cylinder rod is inserted into the front door lock assembly.

Using a "TORX" socket wrench (T30), install the front door lock cylinder with the screw.

Torque:

4.0 N*m{41 kgf*cm, 35 in.*lbf}

Install the hole plug.

Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated in the order of the arrows in the illustration.

Install the front door glass sub-assembly with the 2 bolts.

Torque:

5.5 N*m{56 kgf*cm, 49 in.*lbf}

Apply butyl tape to the front door panel.

Pass the front door lock remote control cable and rear door inside locking cable through a new front door service hole cover.

Install the new service hole cover.

NOTICE:

Securely install the front door service hole cover avoiding wrinkles and air bubbles.

Connect each connector and each clamp.

Install the front No. 1 speaker assembly with the 4 bolts.

Connect the connector.

Engage the 4 claws and install the front door inner glass weatherstrip.

Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

Engage the 2 claws and install the front door inside handle sub-assembly.

Connect each connector.

Engage the front door trim board with the 4 clips of the front door inner glass weatherstrip.

Engage the 9 clips and install the front door trim board to the front door panel.

Install the 3 screws and clip (A).

Connect the connector.

Engage the claw and install the courtesy light assembly.

Engage the 6 claws and install the assist grip cover.

Engage the 3 claws and install the front door inside handle bezel plug.

Engage the 2 clips and install the front door lower frame bracket garnish.